Installing OpenVPN on a Debian VPS

Updated on November 21, 2023
Installing OpenVPN on a Debian VPS header image

Introducing the OpenVPN protocol

OpenVPN is an open source software application that implements virtual private network (VPN) techniques for creating secure point-to-point or site-to-site connections. It uses SSL/TLS for key exchange.

This tutorial explains how to setup your own VPN server in no more than ten minutes, even if you have never used OpenVPN.

OpenVPN Access Server (OpenVPN-AS)

OpenVPN Access Server is a set of installation and configuration tools that simplify the rapid deployment of a VPN remote access solution.

We are going to use OpenVPN-AS to generate SSL certificates and authenticate users in a user-friendly manner.

Accessing VPS as root

Use the following command to manage your VPS as root. You can find the root password on your Vultr account panel.

ssh root@12.34.56.78

Change 12.34.56.78 to the IP address of your VPS. You will be asked for the fingerprint of the server. Accept it, then enter the password for the root user. It is highly recommended to set a new password for the root user. This operation is made easy with the following command:

passwd

You will be asked twice for the new password. Remember to use this password if you need to access the server in future.

Updating your system

Update your system libraries and applications by executing these commands. The first one updates the list of repositories, and the second performs the actual component update.

apt-get update
apt-get upgrade

Installing OpenVPN-AS

If you are running a 64-bit server, use these commands:

wget http://swupdate.openvpn.org/as/openvpn-as-2.0.10-Debian7.amd_64.deb
dpkg -i openvpn-as-2.0.10-Debian7.amd_64.deb

If you are running a 32-bit server, use the following commands instead:

wget http://swupdate.openvpn.org/as/openvpn-as-2.0.10-Debian7.i386.deb
dpkg -i openvpn-as-2.0.10-Debian7.i386.deb

OpenVPN-AS is now installed. Next, we need to set a password for the openvpn user. Run the following:

passwd openvpn

Configuration and administration over the web

The point of OpenVPN is that you can configure it without system administration experience. The administrator user interface will be located at the following URL.

https://12.34.56.78:943/admin

Once again, remember to substitute your IP address.

Creating new users

By default, OpenVPN-AS will authenticate each Linux user on your system. If you would like to add another user, use the command below.

adduser myusername

Running adduser will prompt for a password. The same password is used to access the OpenVPN client installer, which can be obtained at the following URL:

https://12.34.56.78:943

Remember to change the IP address. When visiting this URL, enter the new user details. Next, install the software on your client computer and you can begin using OpenVPN!